Phoenix Simulator | node – Determines which Simulator will be used to read the fluid data from. Group – Specifies a thinkingParticles Group to place the newly generated particles into. Rate | rate_type[0], rate_percent – Sets a multiplier to the base birth rate of the operator. Rate (max prt/s) | rate_type[1], rate_per_sec – Set a limit to the number of particles born per second. Seed | seed – An initial value for the random numbers generator. Lifespan | lifespan – The average lifespan of the generated particles. When Variation (%) is set to 0, all particles have exactly the same lifespan. Variation (%) | lifespan variation – Varies the lifespan of the generated particles. If set to 100%, the shortest living particles will have a live twice shorter than average, and the longest living particles will have double the average Lifespan. Size | size – The average Size of the generated particles. When Variation (%) is set to 0, all particles have exactly the same Size. Variation (%) | size variation – Varies the Size of the generated particles. If set to 100%, the smallest particles are two times smaller than average and the largest particles will have double the average Size. Mass | Mass – The average Mass of the generated particles. When Variation (%) is set to 0, all particles have exactly the same Mass. Variation (%) | mass variation – Varies the Mass of the generated particles. If set to 100%, the lightest particles have Mass two times lower than average and the heaviest particles will have double the average Mass. Combine | combine – Sets the method used to combine the results of the diagrams for Temperature, Smoke and Speed. Add – The values are added. Multiply – The values are multiplied. Biggest – The biggest value is selected. Temperature/Smoke/Speed/Fuel | use_t, use_s, use_v, use_f – Diagrams representing the birth density based on each source channel. Reset – Resets the corresponding diagram with its default content. |