Versions Compared

Old Version 10

changes.mady.by.user Svetlin Nikolov

Saved on

compared with

New Version 11

changes.mady.by.user Svetlin Nikolov

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Step % | rendstep – Specifies the ray marching step of the camera rays as a percentage of the cell size. As the renderer traces rays through the simulator, this value controls how often to get information from the grid. If the this value is more than 100, some cells will start getting skipped and artifacts may appear. If rendering volumetrics with a specific transparency curve, a lower percentage might be necessary so that fine details are not lost. On the other hand, increasing the this value increases the rendering speed. This parameter is used when Mode is set to Volumetric, Volumetric Geometry, Volumetric Heat Haze and Isosurface modes. See the Step % example below.

...